Leveling mount, 5/16-18 x 2" thread length , 1.25" base dia, 2.88"h, 2300 lbs. Load cap lpst leveling mounts swivel 10-15° to all sides of the centerline to adjust to uneven surfaces used for leveling machine tools, electronic racks, benches, etc. Large diameter pad design assures solid support.
- Coupling nut is not recommended to use for installation
- Use nut on tapped hole of 1 - 1 1/2 times the thread diameter being used
- To insure proper leveling mount size, divide the machine weight by the number of mounts required
- This will equal the pounds or load per mount
- Maximum load ratings for leveling mounts with elastomer pad are based on a calculation of 40% distortion to the elastomer pad
- This insures the proper application requirements when using the bore with the non-skid elastomer pad
- For certain minimum quantities, modifications such as lag bolt holes and other versions of plating are available upon request
- Heat resistance for delrin base mounts: continuous operating temperature--82°c (180°f); melting point--175°c (347°f).
- Base diameter 1.25"
- Brand J.W
- Winco
- Construction Yellow zinc plated steel
- Manufacturers part number 5t2lit
- Country of origin Made in usa
- Stud length 2.00"
- Height 2.88"
- Load capacity (lbs.) 2300 lbs.
- Thread 5/16-18
- Load capacity range (lbs.) 1000 - 2500 lbs.
- Unit of measurement Inch (imperial)
- Threaded stud & hex nut Zinc plated steel
